![]() ![]()
If none of that works, or you just don’t want to deal with that message, then continue reading. ![]() Also, if you did change fans, then you can always reconnect the old fan or a new fan or equal size and speed to the SYSFAN slot. From what I can tell the SYS_FAN1 slot monitors the fan speed, so it had been asking me for the system fan ever since because there’s nothing connected to that 3-pin slot.īefore continuing, please note that if you haven’t changed any parts and you suddenly started getting that message, then make sure the fans are really working. You don’t have to change the settings if all you need is to replace a fan, so make sure you check your motherboard’s fans configuration to try to isolate the problem. The system originally came with a 3-pin CPU fan that was connected to a slot labeled on the motherboard as “ SYS_FAN1,” but the new CPU fan that came with the over-sized heat sink has a 4-pin connector that I plugged in into the slot marked as “ CPU_FAN“. The case I am using has two stock fans on the back, and I replaced the stock CPU heasink and fan with a Cooler Master Hyper heatsink/fan combo. American megatrends bios update rca cambio Pc#Thankfully there seems to be a solution.Īfter I upgraded my computer to a new case I started getting the following error during startup/reboot:Įrror: System Fan Has Failed! Service PC to prevent damage to the system. I will NEVER buy another tablet without a reset button (or w/o a touch-screen bios.) Anyone need an 11.6" lighted serving tray.If you replaced the system or CPU fans, or moved the hardware contents of your HP computer to a new case, you might be getting an “F2 fan error” on boot. That made me wonder if it was reading the settings from the built-in SSD, so I disconnected it yet the Bios settings are STILL loading. I decided to try again to disconnect the batteries in hopes of clearing the Cmos, this time attempting to turn the tablet On 4-Times in hopes of draining any capacitors or residual charge then letting it sit for an hour before reconnecting the power, but despite all that, the old Bios settings were STILL there. I tried shorting the pins before, during and after powering on, but nothing made any difference. I obtained the spec sheet and it mentions a "/Reset" pin, but shorting that didn't work either. ![]() Based on some photos I found online, you should be able to reset the Bios by shorting a single pin on the Winbond FlashRAM chip, but that too didn't work. So, left with no other choice, I opened the tablet up. ![]() With a missing OS as the first choice and no way to move the cursor right to select/boot Windows, I can't get past that menu. a third-party (fourth party?) Boot Loader that doesn't support touch screens (which I did not know at the time). On reboot, it reports it "can't find" the linux iso, so there's no OS to install.īut it gets worse. Long story short, "WubiUEFI" didn't work. American megatrends bios update rca cambio windows#a "UEFI compatible" version of "Wubi" (a popular old program that installed other OS and a Boot Menu using Windows that no longer worked on computers with a UEFI Bios). Unfortunately, Windows-10 makes installing additional OS's difficult (so does the UEFI Bios), but I eventually found WubiUEFI. American megatrends bios update rca cambio install#So I searched around looking for a way to install Ubuntu from Windows without a flashdrive. Unable to reset the Bios from Windows, I found several sites claiming it is possible to do it from Linux. Final update for anyone who was following this thread. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |